head
Follow Us On facebook twitter

rantairantairantairantairantairantairantairantairantai
 
office hour
Monday - Saturday
09.30 - 20.00
Sunday : 10.00 - 17.00
PIN BB : 21 FFF 747
Pin BB
21 FFF 747
product
video Nikon D 800
support
support 1
support 2
support 3
support 4
support 5
transaksi
kami menerima transaksi
bca
visa
mastercard
Mengirim ke seluruh wilayah indonesia dengan menggunakan jasa JNE (www.jne.co.id)
product
B+W FILTER IR OR UV BLOCK (STANDARD F-PRO MOUNT)
Resolusi :
LCD :
Battery :
Optical :
Rp. ,-
Non Garansi
-

Model

Harga (Rp)

UV IR CUT MRC 67

1.195.000,-

UV IR CUT MRC 77

1.680.000,-

Description

This B+W Interference Filter has a completely colorless glass carrier coated with a number of extremely thin, partially reflecting layers with precisely computed thicknesses, similar to MC coating. The B+W Filter 486 does not block by means of absorption, but by interference of the unwanted UV and IR radiation that is repeatedly reflected between these layers, affecting the wavelengths on both sides of the visible spectrum with a steep cut-off. It is used mainly on digital and video cameras with CCD sensors without an integrated IR protection filter, because the IR sensitivity of the CCD sensor would otherwise cause color changes and unsharpness. That unsharpness results from the chromatic aberration of the lenses that are only corrected for visible light. In the visible range, the transmission curve is very high and straight. This filter is completely clear and it requires no increase in exposure. Its filter factor is 1.

IMPORTANT NOTE REGARDING WIDE-ANGLE LENSES.

Please note however that, in contrast to mass-colored (integrally colored) filter glass, the (486M) UV-IR cut filter is based on thin-film technology. More than 30 interference coatings are vapor-deposited on one side, while the opposite side is MRC-coated. In wide-angle lenses, the laws of physics lead to shallower incidence angles for peripheral rays. For geometric reasons these rays have to travel further through the interference coatings than rays traveling vertically through the coatings in the center of the lens. With increasing angle of incidence, this leads to a change in light color towards blue. This effect can clearly be seen by looking at an UV-IR barrier filter from an angle. The color of the reflected light changes, with a similar effect on the light traveling through the filter. The filter is therefore not suitable for lens systems with an angle of view of more than 60

Mount

This filter uses our standard B+W F-Pro filter mount made of brass. Compared to the earlier standard mount introduced in 2001, the F-Pro mount has become thinner. Now it can be used with wide angle lenses, including most 24mm focal lengths on a full frame body, without vignetting. Another advantage of the F-Pro mount is it's modified retaining ring, which is no longer threaded in from the front, but holds the filter glass in place from the back. When removing a filter or lens hood that has been screwed on too tight to the filter, the retaining ring is not at risk of loosening.